Assign Mix to Aux Sends

WARNING

This guide assumes the v4 firmware is being used. If you are the v3 firmware, check out the manual.

What Aux are you using? Aux SelectionAux 1Aux 2Aux 3Aux 4Aux 5Aux 6

1. Press the Routing Button next to the screen
2. Press the right arrow to change the currently viewed tab to AUX OUT. It is not on the screen by default, keep pressing right until it appears.
3. Once on the AUX OUT tab, use Encoder 1 (the furthest encoder to the left) to change to your desired aux
4. Use Encoder 3 to change the 'mix' or source that will be assigned to your desired aux. Make sure to press on Encoder 3 to confirm the selection.