Audio Help

Appearance

Sending a Channel to a Monitor Mix ​

WARNING

If the monitor mix bus is set to Post Fade, you will need to make sure the fader for sending the channel to the mains is turned up.

  1. Make sure the channel is displayed on the scribble strips to the left of that button side of the board. Press to corrisponding layer to bring it up if it is not.
  2. Make sure the bus is displayed on the scribble strips on the right side of the board. Press to corrisponding layer to bring it up if it is not.
  3. Select your monitor mix and then press Sends on Faders.
  4. Move your needed channel(s) fader to the desired level.

IMPORTANT

Make sure the monitor fader is turned up! I recommend starting at -5db so you have room when they ask for the whole mix to be turned up during the show.